Category: home security

– To connect motion detectors use two wires of 12v 16v DC and two wires for the alarm circuit. Sometimes, the pets roaming in these areas cause alarm activation. So, one should be careful about false alarms. Now-a-days, special motion detectors are available to avoid false alarms.

– The sensors installed in the home should be connected by low voltage wiring that is routed through walls to the central controller termination strip.

– RG-6 cable and F-type coaxial connector hardware should be used to run the cable from the camera to the monitor or switching equipment. Video surveillance cameras can be installed using the supplied mounting hardware. Selection of proper location is very important because the full view of the area can be observed if located properly.

Burglar alarm wiring is used for connecting sensors to the main control panel. It is generally low voltage, limited energy circuit wiring that is done with #22-gauge wire. The most commonly used wire is quad wire. It has four wires enclosed in a plastic sheath and is used for interconnecting security system components.

The installation of wiring system is very important because it makes the overall security system robust and efficient. Hence, the following points must be considered during installation of wiring system:

– The wiring system should be installed when the building is being constructed. It must be installed prior to dry wall installation.

– All low voltage wires running parallel to AC power cables should be separated by at least 12 inches.

– An RJ-31x jack should be used between the off-premise telephone line and the alarm panel to provide priority for the alarm system.

– All wiring must terminate in an alarm or a control panel grounded to a true earth ground.

– One must remember that when security wire and cabling is crossed with AC power wires, the crossover must be at a 90 angle.

– RG-59 or RG-6 coaxial cable with 95% copper braid should be used for video surveillance.

– Alignment of the sensors and cabling devices should be as per National Fire Protection Association, the National Electrical Code and the National Fire Alarm Code. For example, although any gauge wire can be used for connecting sensors to the control panel, #22-gauge is the smallest gauge wire that should be used for wiring home security systems.

Burglar alarm wiring is used for connecting sensors to the main control panel. It is generally low voltage, limited energy circuit wiring that is done with #22-gauge wire. The most commonly used wire is quad wire. It has four wires enclosed in a plastic sheath and is used for interconnecting security system components.

The installation of wiring system is very important because it makes the overall security system robust and efficient. Hence, the following points must be considered during installation of wiring system:

– The wiring system should be installed when the building is being constructed. It must be installed prior to dry wall installation.

– All low voltage wires running parallel to AC power cables should be separated by at least 12 inches.

– An RJ-31x jack should be used between the off-premise telephone line and the alarm panel to provide priority for the alarm system.

– All wiring must terminate in an alarm or a control panel grounded to a true earth ground.

– One must remember that when security wire and cabling is crossed with AC power wires, the crossover must be at a 90 angle.

– RG-59 or RG-6 coaxial cable with 95% copper braid should be used for video surveillance.

– Alignment of the sensors and cabling devices should be as per National Fire Protection Association, the National Electrical Code and the National Fire Alarm Code. For example, although any gauge wire can be used for connecting sensors to the control panel, #22-gauge is the smallest gauge wire that should be used for wiring home security systems.

Also check solar power energy