Connecting the motion detectors in your alarm system
- To connect motion detectors use two wires of 12v 16v DC and two wires for the alarm circuit. Sometimes, the pets roaming in these areas cause alarm activation. So, one should be careful about false alarms. Now-a-days, special motion detectors are available to avoid false alarms.
- The sensors installed in the home should be connected by low voltage wiring that is routed through walls to the central controller termination strip.
- RG-6 cable and F-type coaxial connector hardware should be used to run the cable from the camera to the monitor or switching equipment. Video surveillance cameras can be installed using the supplied mounting hardware. Selection of proper location is very important because the full view of the area can be observed if located properly.
Keywords: Home Security
